Frisco Tree Care Home › Tree Work › Stump Grinding
Stump Grinding in Frisco
The stump is the one part of a removal that is in the ground with everything else the builder buried.
What Grinding Is
A grinder is a spinning toothed wheel that chews the stump into chips, down to a depth below the lawn surface. It does not pull the roots. The large roots stay in the ground and rot over the following years.
How deep depends on what goes there next. Sod only needs the stump taken a few inches under the surface. A new tree, a flower bed or a patio footing needs more. Tell the crew the plan so the quote matches it.
You are left with a mound of chips mixed with soil, usually more volume than the stump looked like it held. A quote either includes hauling the chips and bringing in soil, or it leaves the pile for you. Ask which.
What Is Under a Frisco Front Yard
On a lot built in the last thirty years, the strip between the house and the street carries most of the buried services, and nearly every lawn has an irrigation system threaded through it. Builder trees were planted after those lines went in, often right beside them.
- Call 811 first. Texas811 marks buried public utilities at no charge, and a locate request should be in before a grinder goes into the ground. The tree service normally places it. Locators mark public utilities; they do not mark sprinkler pipe.
- Irrigation is on you to point out. Know where the heads and the valve box are. A grinder will cut a sprinkler line without the operator feeling it.
- Surface roots run under sidewalks. Grinding stops at the concrete. A root that has lifted a public sidewalk panel is a question for the city or HOA, whoever maintains that walk.
Repairing a cut sprinkler line is irrigation work, which Texas licenses separately. A tree crew that nicks a line should tell you; fixing it belongs to a licensed irrigator.
Replanting in the Same Spot
If the lot has to keep a required number of trees, the stump's location is the obvious place for the replacement, and it is a poor one. The soil is full of chips and old roots. Planting a few feet to one side, in undisturbed ground, gives a new tree a better start. Frisco's planting rules also set distances to keep in mind: at least six feet behind the curb and four feet from pavement and utility lines.
The city publishes a list of approved plants and its parks department names several trees that grow well here, among them bur oak, cedar elm, lacey oak, red oak and Texas redbud. A nursery or a certified arborist can match one to the space.
Questions People Ask First
Can I leave the stump?
On private property, generally yes, unless the HOA objects. It will sprout on some species and it will be in the way of a mower for years.
How soon after removal can it be ground?
Any time. Many crews grind the same day. A fresh stump and a ten-year-old one grind about the same.
Will grinding kill the roots?
It removes the stump, and most species die back after that. A few send up shoots from remaining roots for a season or two.
Does grinding need a permit?
This site found no Frisco permit for grinding a stump on a platted residential lot. A locate request through 811 is the step to take before grinding.
One Stump or Several
Say how wide it is at the ground and what you want to put there afterward.
Call (469) 200-6710 Use the Form